收藏本站
FDS_6533_6534_004
71M6533/G/H and 71M6534/H Data Sheet
1.5
1.5.1
On-Chip Resources
Oscillator
The 71M6533/71M6534 oscillator drives a standard 32.768 kHz watch crystal. These crystals are accurate
and do not require a high-current oscillator circuit. The oscillator has been designed specifically to handle
these crystals and is compatible with their high impedance and limited power handling capability. The
oscillator power dissipation is very low to maximize the lifetime of any battery attached to VBAT.
Oscillator calibration can improve the accuracy of both the RTC and metering. Refer to Section 1.5.3
Real-Time Clock (RTC) for more information.
The oscillator is powered directly and only from VBAT, which therefore must be connected to a DC voltage
source. The oscillator requires approximately 100 nA, which is negligible compared to the internal leakage
of a battery.
The oscillator may appear to work when VBAT is not connected, but this mode of operation is not
recommended.
If VBAT is connected to a drained battery or disconnected, a battery test that sets BME may drain
VBAT’s supply and cause the oscillator to stop. A stopped oscillator may force the device to reset.
Therefore, an unexpected reset during a battery test should be interpreted as a battery failure.
1.5.2
PLL and Internal Clocks
Timing for the device is derived from the 32.768 kHz crystal oscillator output. On-chip timing functions
include:
?
?
?
?
?
The MPU clock (CKMPU)
The emulator clock (2 x CKMPU)
The clock for the CE (CKCE)
The clock driving the delta-sigma ADC along with the FIR (CKADC, CKFIR)
A real time clock (RTC).
The two general-purpose counter/timers contained in the MPU are controlled by CKMPU (see Timers and
Counters ). Table 37 provides a summary of the clock functions provided.
Table 37: Clock System Summary
÷ 2 / [1,0]
÷ 3 / [0,1]
÷ 4 / [0,0]
Clock
Derived
From
MCK Divider / [ M40MHZ, M26MHZ ]
**
Brownout Mode
32 kHz
CKPLL
MCK
Crystal
CKPLL
78.6432 MHz
39.3216 MHz
78.6432 MHz
26.2144 MHz
78.6432 MHz
19.6608 MHz
Off
112 kHz
CKCE
MCK
4.9152
MHz ?
9.8304
MHz ?
6.5536 MHz
4.9152 MHz
Off
6.5536 MHz
4.9152 MHz
CKADC / CKFIR
CKMPU maximum
MCK
MCK
4.9152 MHz
9.8304 MHz ***
6.5536 MHz
***
4.9152 MHz
***
28 kHz
28 kHz
Default state at power-up
This is the maximum CKMPU frequency. CKMPU can be reduced from this rate using MPU_DIV[2:0].
CKCE = 9.8304 MHz when CE10MHZ is set, 4.9152 MHz otherwise.
CK32 MCK 32.768 kHz 32.768 kHz 32.768 kHz
**
***
?
The master clock, MCK, is generated by an on-chip PLL that multiplies the crystal oscillator output frequency
(CK32) by 2400 to provide 80 MHz (78.6432 MHz). A divider controlled by the I/O RAM registers
M40MHZ and M26MHZ permits scaling of MCK by ?, ? , and ?. All other clocks are derived from this
scaled MCK output (making them multiples of 32768 Hz), and the clock skew is matched so that the rising
edges of CKADC, CKCE, CK32, and CKMPU are aligned.
Rev 2
37
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
71M6543F-IGT/F IC ENERGY METERING
71M6545-IGT/F IC ENERGY METERING
720-10007-00300 CBL D-SUB 9PIN FMAL-25PIN FML 3M
720-10010-00025 CBL DSUB 9PIN FML-25PIN MAL .25M
720-10020-00300 CBL DSUB 9PIN FML-9PIN MALE 3M
720-10021-00300 CBL DSUB 9PIN FML-9PIN FEMAL 3M
72231-0881 8 POS T/P SHLD 4 GR ASSY
7250B PANEL KIT BOTTOM FOR R-1220 CASE
相关代理商/技术参数
71M6533H 制造商:TERIDIAN 制造商全称:TERIDIAN 功能描述:Energy Meter IC
71M6533H-IEL 制造商:Maxim Integrated Products 功能描述:Metering Systems on a Chip - SoC Precision Energy Meter IC
71M6533H-IEL/F 制造商:Maxim Integrated Products 功能描述:Metering Systems on a Chip - SoC Precision Energy Meter IC
71M6533H-IELR 制造商:Maxim Integrated Products 功能描述:Metering Systems on a Chip - SoC Precision Energy Meter IC
71M6533H-IELR/F 制造商:Maxim Integrated Products 功能描述:Metering Systems on a Chip - SoC Precision Energy Meter IC
71M6533H-IGT/F 功能描述:计量片上系统 - SoC Precision Energy Meter IC RoHS:否 制造商:Maxim Integrated 核心:80515 MPU 处理器系列:71M6511 类型:Metering SoC 最大时钟频率:70 Hz 程序存储器大小:64 KB 数据 RAM 大小:7 KB 接口类型:UART 可编程输入/输出端数量:12 片上 ADC: 安装风格:SMD/SMT 封装 / 箱体:LQFP-64 封装:Reel
71M6533H-IGT/F1 功能描述:计量片上系统 - SoC RoHS:否 制造商:Maxim Integrated 核心:80515 MPU 处理器系列:71M6511 类型:Metering SoC 最大时钟频率:70 Hz 程序存储器大小:64 KB 数据 RAM 大小:7 KB 接口类型:UART 可编程输入/输出端数量:12 片上 ADC: 安装风格:SMD/SMT 封装 / 箱体:LQFP-64 封装:Reel
71M6533H-IGTR/F 功能描述:计量片上系统 - SoC Precision Energy Meter IC RoHS:否 制造商:Maxim Integrated 核心:80515 MPU 处理器系列:71M6511 类型:Metering SoC 最大时钟频率:70 Hz 程序存储器大小:64 KB 数据 RAM 大小:7 KB 接口类型:UART 可编程输入/输出端数量:12 片上 ADC: 安装风格:SMD/SMT 封装 / 箱体:LQFP-64 封装:Reel